How to Install Linksys AC1900 / RE7000

Steps for RE7000 Linksys AC1900 -- How to Factory reset – If needed

Press and hold the reset button until the power light on the front of the range extender blinks to reset to factory defaults

Installation Instructions – DO NOT USE THE LINKSYS Quick Start Guide

1. Delete the camera from the app, Red LEDs flash
2. Factory reset the camera – Hold power button in for 10 – 12 seconds until Red ring flashes
3. Remove the battery from the camera
4. Plugin RE7000 near the Hub
   • Blinks green = loading
   • Blinks amber = ready to pair
5. Push WPS on Extender – The button goes solid amber
6. Push WPS on Hub – blinks white
7. Watch the Extender – Blinks (green and amber) – wait for solid green (might be two full minutes)
8. Move the Extender – plug it in
9. Watch the Extender – Blinks (green and amber) – wait for solid green (might be two full minutes)
   • Check indicator LED for connection quality. It can take up to 2 minutes for the ranger extender to boot up after moving it. During this period, you will see the blinking green LED once again
     • Solid green = Ready to use
     • Solid amber = Weak connection to the router. Find an outlet closer to your router
     • Blinking amber = Not connected to the router. Find an outlet closer to your router
10. Push WPS on Extender – The button goes solid amber
11. Insert the battery into the camera and press the power button
12. Watch the Extender – Blinks (green and amber) – wait for solid green (might be two full minutes)
13. The camera may say Pairing, then Camera Connected, may not say anything
14. Check the app – Camera will be in Initial state – go through the steps to make it online